Does anyone have stock baseline rwhp numbers? Iam trying to compile an average. I know every dyno will produce different results. Also any information on percentage losses through the drive train. Thank you for your time.

zzilla:

I suggest you go up on the D3 site http://www.d3cadillac.com/


They have done a number of "V" stock to high performance upgrades and have the baselines for their runs.


Factory Performance – Cadillac XLR
320HP @ 6400 RPM
310TQ @ 4400 RPM
-------------
Factory Performance – Cadillac XLR-V
443HP @ 6400 RPM
414TQ @ 3900 RPM

I just had a baseline dyno last weekend at Vengeance Racing in Cumming, GA
Bone stock the numbers were 356 hp with 363 torque. Better numbers than my 2006 C-6 LS2. These are rear wheel numbers. The factory numbers are at the crankshaft which will be higher. I am have it performance tuned at Xtrememotorsports in Blountstown, FL in three weeks and will post the results after the tune. Pretty impressive considering they had a dyno day for the CTS's and most were V's. My numbers were better than most if I remember right. They were the LS1 and LS2. Fun to have a blown caddy that plays nice with my vettes.:yesnod:yesnod:yesnod:yesnod:yesnod

I installed an induction system and remapped the MAF sensor to lean the car out to deliver a more consistant ratio over the speed range. Here are the graphs on a 06 XLR-V before and after.

Bob

http://i180.photobucket.com/albums/x161/rleonard1/XLR/P2270004.jpg

http://i180.photobucket.com/albums/x161/rleonard1/XLR/Graph.jpg

REAL NICE NUMBERS!!!!!

When you get a chance check the Lund Cadillac site, Mallet Performance site and the D3 Performance site for their numbers and packages...interesting stuff.....

Please do post you next runs.

Regards

Just got back from Xtrememotorsports for my tune and the numbers were:
381 rwhp and 388 ft/lbs torque. That is "bone stock" with no bolt ons, yet, just a tune:yesnod:yesnod:cheers:cheers

Exactly where is Blountstown, FL? I've never heard of it. Is it near Tampa or Orlando??

Regards

Exactly where is Blountstown, FL? I've never heard of it. Is it near Tampa or Orlando??

Regards
Hwy 71 between Tallahassee and Panama City

Xtreme Motorsports
16119 Highway 71 S.
Blountstown, FL 32424
(850) 907-9100

Just tell Chris Don Luther sent you
http://www.motorsportsxtreme.com/

You know I have wanted to travel over your way (Pensacola Naval Air Station) for awhile now.

This is just one more reason to get out of Jacksonville for awhile and see the rest of Florida.I am embarassed that I don't try and see more of it since I was born in Miami Beach (a true native).

For obvious reasons I will be following your "V" projects with much interest. Can you post your dyno sheets and exactly what they did?

Best Wishes

Jerry

You know I have wanted to travel over your way (Pensacola Naval Air Station) for awhile now.

This is just one more reason to get out of Jacksonville for awhile and see the rest of Florida.I am embarassed that I don't try and see more of it since I was born in Miami Beach (a true native).

For obvious reasons I will be following your "V" projects with much interest. Can you post your dyno sheets and exactly what they did?

Best Wishes

Jerry

I'll post the dyno sheet this afternoon. What all was done you'd have to ask Chris Harwood (owner of Xtrememotorsports)

http://216.77.188.54/coDataImages/p/Groups/227/227482/folders/166791/2411322image.jpg

Dyno from tune at Xtrememotorsports